The short answer
In a gas furnace, the heat exchanger keeps burning fuel and its exhaust separate from the air blown into your home. If it cracks or the venting fails, combustion gases including carbon monoxide can escape. Working CO alarms, yearly furnace inspections, and prompt action on warning signs are your protection.
Written by Comfort Systems of York County team
Last updated
Definition
What does a heat exchanger do?
When your gas furnace runs, burners fire inside a sealed metal chamber called the heat exchanger. The blower pushes house air across the outside of that chamber, picking up heat. The exhaust stays inside and leaves through the flue or vent pipe.
Carbon monoxide is a colorless, odorless gas produced when fuel burns. A healthy, properly vented furnace sends it outside. Our blog has more detail on what a heat exchanger is.
When it applies
When should you treat a furnace as a safety concern?
Take these signs seriously:
- A CO alarm sounds. Leave the house first, then call 911 or your gas utility.
- The burner flame looks yellow, flickering, or lifts off the burners instead of burning steady blue.
- Soot or scorch marks appear around the furnace or vent connections.
- A strong burning or chemical smell that doesn't fade after the first run of the season. See burning smells from a furnace.
Failure modes
What safety mistakes do homeowners make?
Most furnace safety problems are preventable.
- No CO alarms, or alarms with dead batteries. Follow the alarm maker's placement and testing instructions.
- Storing paint, gas cans, or boxes against the furnace.
- Skipping inspections for years on an older furnace.
- Resetting a furnace again and again after it locks out, instead of finding why the safety controls tripped.
Proof
What does our inspection cover?
During a heating tune-up we inspect the burners, flame sensor, venting, and the visible parts of the heat exchanger, and we check safety controls. If we find a problem we explain it and show you what we saw. Comfort Club members get two tune-ups a year, so the furnace gets looked at before heating season.
Next step
What should you do now?
Test your CO alarms, clear the space around the furnace, and book a heating tune-up before the first cold snap. If a furnace problem is serious enough to raise replacement, read dual fuel to see what a new system could look like. For an alarm sounding now, leave the home and call 911 first.
Common questions
- What should I do if my carbon monoxide alarm goes off?
- Get everyone outside to fresh air, then call 911 or your gas utility from outside. Don't go back in until emergency responders say it's safe. Then call us to inspect the furnace.
- Can a technician see a cracked heat exchanger?
- Sometimes. Some cracks are visible during an inspection; others need closer testing. We'll explain what we found and how we found it.
Where to go next
- Learn What Happens at an HVAC Tune-Up
What a technician checks, cleans, and tests, and what you should hear back afterward.
- Compare Heat Pump, Furnace, or Both? Dual Fuel Explained
How a heat pump and a gas furnace split the work, and when pairing them makes sense in York County.
- Act HVAC Emergency? What to Do Before the Technician Arrives
Calm, safe steps for no heat, no cooling, water, burning smells, or a CO alarm.
- Service
- Furnace repair
- Near you
- Heating service in Rock Hill
- Next step
- Book a heating tune-up
From our blog
← Back to the Learning Center HVAC glossary
How we wrote this: general guidance from Comfort Systems of York County, based on the work we do across York, Chester, and Lancaster Counties and the greater Charlotte area. It isn't a quote or a diagnosis. Every home is different, so a technician's inspection comes first.