The short answer
Compare HVAC quotes on scope before price. Check that each one lists the matched indoor and outdoor equipment, SEER2 and HSPF2 ratings, how the system was sized, ductwork work included, permits, removal of old equipment, labor warranty, and payment terms. Two quotes for different scopes aren't really comparable.
Written by Comfort Systems of York County team
Last updated
Definition
What makes two quotes comparable?
A replacement quote is a list of decisions: which equipment, how big, what efficiency, what gets replaced alongside it, and what's covered afterward. When two quotes differ in price, the difference is usually hiding in one of those lines.
Lay the quotes side by side and fill in the same checklist for each. Where a quote is silent, ask.
Price differences are normal. Two honest contractors can quote the same house differently because they recommend different equipment, different staging, or different ductwork work. The checklist below helps you see whether you're looking at a difference in price or a difference in what's included.
When it applies
What should every quote spell out?
Look for these lines:
- Make and model numbers for both the outdoor unit and the indoor coil or air handler.
- SEER2 (and HSPF2 for heat pumps) for the matched system, and the tonnage.
- Whether a load calculation was done, and what ductwork repair or sealing is included.
- Permit, removal of old equipment, labor warranty length, and any guarantee terms in writing.
Failure modes
What red flags should you watch for?
Be cautious when you see:
- Only the outdoor unit listed, with no mention of the indoor coil.
- Sizing "same as the old one" with no measurements taken.
- Pressure to sign before the salesperson leaves.
- Verbal promises about efficiency or warranties that aren't on paper.
Proof
What do our estimates include?
Our in-home estimates are free. Replacements come with a 1-year No Lemons guarantee, and extended labor warranties are available up to 10 years. We're an Armstrong Air Pro Team dealer, licensed in SC (#112349) and NC (#31373), and we're happy to walk through a competitor's quote with you line by line.
We'd rather you understand a quote than feel rushed into one. If our quote and another one differ, we'll explain where and why, and if the other quote covers something ours doesn't, we'll say so.
Next step
What's the next step?
Use this checklist on every quote you get. Brush up on SEER2 and permit basics, then request a free in-home estimate. If cost is the sticking point, see financing basics.
Common questions
- Should every quote include a load calculation?
- Ask for one. A load calculation sizes equipment to your home rather than to the old unit's label. If a quote doesn't mention how the system was sized, ask the contractor to explain it.
- Should I just pick the lower-priced HVAC quote?
- Compare scope first. A lower quote may leave out the indoor coil, ductwork, permits, or warranty coverage that another includes.
- Will you review another company's quote?
- Yes. Bring it to your free in-home estimate and we'll go through it line by line.
Where to go next
- Learn What SEER2 Means When You Shop for a New System
The efficiency number on every AC and heat pump quote, explained without the sales pitch.
- Compare Repair or Replace Your HVAC System?
Age, repair cost, refrigerant, and comfort: the four things that actually decide it.
- Act What to Expect From a Free In-Home Replacement Estimate
What we measure, what you'll get in writing, and the questions worth asking us.
- Act HVAC Financing Basics
How financing a new system works with us, who the lenders are, and the questions to ask.
- Service
- AC installation
- Near you
- HVAC service in Charlotte, NC
- Next step
- Request a free in-home estimate
← Back to the Learning Center HVAC glossary
How we wrote this: general guidance from Comfort Systems of York County, based on the work we do across York, Chester, and Lancaster Counties and the greater Charlotte area. It isn't a quote or a diagnosis. Every home is different, so a technician's inspection comes first.